V-TAC VT-6055-3 - User Manual

SAFETY INSTRUCTIONS
• Make sure that the mains voltage matches the voltage stated on the rating label of the
appliance.
• Check the power cord regularly for visible damage. If the cord is damaged, it must be
replaced by the official Technical Support Service, in order to avoid any type of danger.
WARNING: Do not use the appliance if its cord, plug, or housing is damaged, nor after it
malfunctions or has been dropped or damaged in any way.
• The appliance is not intended to be used by children under the age of 8. It can be used by
children over the age of 8, as long as they are given continuous supervision.
• This appliance is not intended to be used by persons with reduced physical, sensory, or
mental capabilities, or lack of experience or knowledge, unless they have been given supervi-
sion or instruction concerning the use of the appliance in a safe way by a person responsible
for their safety, and understand the hazards involved.
• Supervise young children to make sure that they do not play with the appliance. Close
supervision is necessary when the appliance is being used by or near children.
• Keep the appliance and its cord out of reach of children under the age of 8.
• Do not try to repair the appliance by yourself. Contact the official Technical Support Service
for advice.
• Cleaning and maintenance must be carried out according to this instruction manual to make
sure the appliance functions properly. Turn off and unplug the appliance before cleaning it.
• Make sure the fan is not placed near drapes, curtains, or any objects that may be drawn into
the fan.
• The minimum distance between the fan blades and the floor must be 2.3 m. The minimum
carrying capacity of the outlet box from which the fan is hung must be 45 kg.

Summary

Safety Instructions

General Safety and Warnings

Covers mains voltage, cord damage, and warnings about using damaged appliances.

Child Safety and Supervision

Guidelines for children under 8, supervision requirements, and keeping the appliance out of reach.

Operational and Maintenance Safety

Covers self-repair prohibition, cleaning procedures, and safe placement near objects.

Introduction and Warranty

Warranty Information

Details the warranty period, coverage, and conditions for V-TAC products.

Technical Data

Parts and Components

Required Tools

Lists the tools and materials not included with the fan that are necessary for installation.

Product Assembly: Before Use

Mounting Bracket Installation

Instructions for securely attaching the mounting bracket to the ceiling surface.

Product Assembly: Down Rod

Down Rod and Hanger Ball Setup

Steps for installing the down rod and hanger ball onto the fan motor assembly.

Product Assembly: Hanging and Wiring

Hanging Fan and Blades

Procedure for hanging the fan onto the mounting bracket and attaching the blades.

Remote Control and Wiring

Instructions for connecting the remote control receiver and fan wires.

Wiring Diagram

Product Assembly: Blade Attachment

Securing Fan Blades

Details on how to correctly insert and tighten the fan blades to the motor.

Product Assembly: Light Fixture

Installing Light and Glass Shade

Guide for attaching the LED light and securing the glass shade to the fan.

Operation

Fan Direction Control

Explains how to use the direction switch for winter and summer airflow modes.

Remote Control

Replacing Remote Batteries

Instructions on how to open the remote and replace the battery.

Cleaning and Maintenance

Troubleshooting: Fan Issues

Fan Not Starting Up

Steps to check fuses, circuit breakers, and wire connections when the fan fails to start.

Fan Emits Noises

Diagnosing and resolving common noises from blades, motor, or light kit.

Low Airflow

Troubleshooting reasons for reduced or inadequate airflow from the fan.

Troubleshooting: Fan Wobbling

Fixing Fan Wobble

Instructions to ensure stability by tightening mounting brackets and blade screws.

V-TAC VT-6055-3 Specifications

General

Model	VT-6055-3
Category	Fan
Voltage	220-240V
Frequency	50Hz
Speed Settings	3
Material	Metal and Plastic