-17-
3. Empty the tank into a sink or toilet. Rinse the tank thoroughly with clean water.
If continuing to use after emptying the dirty water tank, be sure to dry the
outside of the tank before reinstalling.
4. Insert the locking tabs into the slots of the dirty water tank rst and then secure
the dirty water tank cover back into place until a click is heard.
5. Reinstall the dirty water tank back onto the unit. The security latch will
automatically secure the dirty water tank in position. A click will be heard when
correctly installed.
WARNING
The motor noise changes to a higher pitch when the dirty water tank is full or
blocked. Stop the spot cleaner immediately and empty the dirty water tank.
To Next Page
Loading...