11
ARY, Inc. | 5200 W 110th Street Suite 200, Overland Park, KS 66211 | www.VacMasterFresh.com | 800-821-7849
VP220 Chamber Vacuum Sealer | User Guide
Troubleshooting
VP220 will not turn on:
▫ Make sure the machine is properly plugged into a grounded outlet.
▫ Check the power cord for tears and frays. Do not use this machine
if the power cord is damaged.
▫ Make sure the power switch is turned on. The LED screen will be
illuminated when on.
▫ If you see ‘F1’ displayed on the LED screen and the machine will not
function, make sure the lid is open and turn the power off. Turn
the machine back on and it should return to working order.
VP220 does not pull a complete vacuum with pouch:
▫ The vacuum time may not be set high enough. Set the vacuum
time higher and vacuum again.
▫ To vacuum and seal properly, the opening of the pouch must be
within the vacuum chamber. For detailed instructions, refer to
"How To Use the VacMaster® VP220 Chamber Vacuum Sealer" on
page 10.
▫ The seal bar, lid gasket and vacuum pouch need to be clean, dry
and free of debris for the vacuum process to be successful. Wipe
surface of the seal bar, lid gasket and the inside of the pouch and
try again.
Vacuum pouch loses vacuum after being sealed:
▫ Sharp items can poke small holes in pouches. To prevent this,
cover sharp edges with a paper towel or VacMaster® Bone Guard
and vacuum in a new pouch.
VP220 is not sealing pouch properly:
▫ The seal time may not be long enough. Increase the seal time and
try again.
▫ Pouches will not seal if any moisture, food particles or debris are
present in the seal area. Wipe the inside of the pouch clean and
try again.
▫ Pouches must be properly placed along the seal bar. Make sure
the entire pouch is over the seal bar and there are no wrinkles in
the pouch material.
If problems persist, contact customer support at
(800) 821-7849
To Next Page
Loading...
