Vacmaster VZA306P 1101 - Maintenance Procedures; Emptying the Collection Tank; Removing & Cleaning the Pre-Filter; Removing & Cleaning the Air Inlet Filter

9
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. Disconnect the hose from the vacuum by turning counter-clockwise (Fig. 2).
3. Undo the latches and remove the power head from the collection tank (Fig. 3). Place power
head on a soft, clean surface upside down.
4. Clear all dirt or debris from the collection tank and hose into a proper waste container.
5. Clean or replace the lters .
6. Check the hose, attachments, and power cord to verify that they have not been damaged.
7. Place power head on collection tank and secure latches.
MAINTENANCE
1
2
3
4
5
6
7
8
9
10
11
12
EMPTYING THE COLLECTION TANK
WARNING:
ALWAYS DISCONNECT THE PLUG FROM THE POWER OUTLET
BEFORE REMOVING THE POWER HEAD FROM COLLECTION TANK.
REMOVING & CLEANING THE PRE-FILTER
1. Verify that the power cord is disconnected from the outlet.
2. Remove the pre-lter up (Fig. 4).
3. Clean the pre-lter by gently tapping or brushing dirt off. If necessary, gently rinse the pre-lter
with clean water. Do not scrub or brush the pre-lter. Allow the pre-lter to air dry for 24 hours
before re-installing. DO NOT install pre-lter if it is damp, or it will damage the machine.
4. For optimal performance it is recommended to periodically replace the pre-lter.
REMOVING & CLEANING THE AIR INLET FILTER
1. Verify that the power cord is disconnected from the outlet.
2. With the removed power head in an upside down position, carefully remove the air inlet lter
from the tabs (Fig.5).
3. Wash and rinse the air inlet lter with clean water (Fig. 6).
4. Allow the wet lter to air dry for 24 hours before re-installing.
CAUTION:
Make sure that the pre-lter and air inlet lter are dry before use, otherwise it
may cause poor cleaning performance or damage to the motor.