To Next PageTo Next PageWhat to do if venting valve does not respond on vacuubrand Vacuum Cleaner?
If the venting valve on your vacuubrand Vacuum Cleaner does not respond and the valve symbol is displayed, it is possible that the venting valve is contaminated. Clean the valve to resolve this issue.
Why internal venting valve does not respond on vacuubrand Vacuum Cleaner?
If the internal venting valve of your vacuubrand Vacuum Cleaner does not respond and the valve symbol is not displayed, it indicates that an external pressure transducer is connected and active. Select the internal pressure transducer or connect the external venting valve.
Why is vacuubrand Vacuum Cleaner pump too noisy?
If your vacuubrand Vacuum Cleaner is too noisy, it could be due to the following reasons: * Atmospheric or high pressure at the pump inlet. Connect a hose or silencer to the pump outlet, being careful not to cause outlet overpressure, especially with condensable vapors. * Diaphragm crack or diaphragm clamping disc loose. Perform maintenance.
What to do if 'arrow up' is flashing on vacuubrand Vacuum Cleaner?
If the “Vac control” function on your vacuubrand Vacuum Cleaner stops and the “arrow up” is flashing, it indicates that the preset maximum pressure has been exceeded. Confirm by pressing the START/STOP key. Change the maximum pressure value if necessary.
General| Pumping speed | 30 l/min |
|---|---|
| Permissible ambient temperature | 10 – 40 °C |
| Noise level | 48 dB |
| Voltage | 230 V |
| Frequency | 50/60 Hz |
Critical instructions regarding manual handling, accessibility, and equipment modification.
Defines the proper and intended applications of the vacuum pump and system components.
Instructions for the correct and safe installation and setup of the vacuum unit.
Explanation of ATEX equipment marking, classification, and operational restrictions.
Provides key performance metrics, electrical data, and physical properties applicable to all units.
Instructions for connecting the pump to a vacuum system, including safety precautions.
Guidance on using Pump down or Vac control functions for filtration processes.
Procedures for adjusting the pressure transducer at atmospheric pressure and under vacuum.
Details on configuring the controller's serial interface (RS-232C) for communication.
List of available accessories, including sensors, cables, and condensers, with part numbers.
Steps to adjust the pressure transducer reading to the current atmospheric pressure.
Procedure for adjusting the pressure transducer to zero under vacuum conditions.
Method for adjusting the transducer using a known reference pressure.
Configuring Baud rate, parity, handshake, and remote settings for the RS-232 interface.
Procedure for disassembling and inspecting pump head components and condensers.
Step-by-step guide for replacing the diaphragm, including proper torque and part alignment.
