EasyManua.ls Logo

Vaderstad E-Services TPF Series - Page 63

Vaderstad E-Services TPF Series
68 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Alarm list, ISOBUS/E-Control
47. Doubles The number of doubles exceeds the programmed value.
48. Start of output Output has begun within the preset time limit. Time limit 10 seconds.
49. Level sensor: fertiliser Check the fertiliser level in the metering unit where the level sensors are placed.
If there is fertiliser in the
hopper.
The sensitivity of the sensor has been incorrectly set.
Level sensor for fertiliser,
left sensor
Check the fertiliser level in the metering unit where the level sensors are placed.
If there is fertiliser in the
hopper.
The sensitivity of the sensor has been incorrectly set.
51. Level sensor for
fertiliser, right sensor
Check the fertiliser level in the metering unit where the level sensors are placed.
If there is fertiliser in the
hopper.
The sensitivity of the sensor has been incorrectly set.
52. Level sensor for
fertiliser, both left and right
sensors
Check the fertiliser level in the metering unit where the level sensors are placed.
If there is fertiliser in the
hopper.
The sensitivity of the sensor has been incorrectly set.
53. Level sensor error Check the sensors cable, contacts and connections.
Check that the sensor is not dirty or damp. Wipe the sensor clean with a dry cloth.
The sensor may be defective.
54. Level sensor error, left
sensor
Check the sensors cable, contacts and connections.
Check that the sensor is not dirty or damp. Wipe the sensor clean with a dry cloth.
The sensor may be defective.
55. Level sensor error,
right sensor
Check the sensors cable, contacts and connections.
Check that the sensor is not dirty or damp. Wipe the sensor clean with a dry cloth.
The sensor may be defective.
56. Level sensor error, both
left and right sensors
Check the sensors cable, contacts and connections.
Check that the sensor is not dirty or damp. Wipe the sensor clean with a dry cloth.
The sensor may be defective.
57. Error in radar signal An abnormal change in radar speed has been detected.
If the error repeats, check the cabling, connectors and connections.
Recalibrate the radar
The sensor may be defective.
903075-en-gb; 07.06.2017 59

Table of Contents

Related product manuals