Vaderstad Seed Hawk - Page 32

Toolbar Check
Condition
Check Specication Comments
Ok
Repair
Replace
Hitch pin & safety
chain
Check for wear or damage
Air pack / Manifold
Check for defects / damages
turn primary hoses as
required
Check towers &
secondary hoses
Check loose hardware or
kinked hoses
Blockage ECU’s
Inspect, conrm ecu acoustic
tubes are not kinked
or damaged
Shanks
Check condition and torque
throughout toolbar
Hydraulic System
Check for any leaks or
defects on valve blocks and
openers
Check seed & fertil-
izer boots
Check wear, adjust if needed,
tighten hose clamps
Check toolbar tires
/ wheels
Adjust pressure / Check
condition & wheel torque
Wing Cylinders
Check for any visible defects or
leaks. Conrm correct wing
pressures are present
Castors
Check castor plate to
weldment gap is less than
1/8th inch. Adjust as required
Frame Check for any visible defects
Grease
Grease all hubs, castors, pivot
points, packer wheels and re-
pack spindles as per service
manual
Torques
Check all main wing and center
wing torque
Safety decals
and lights
Check for any visible defects /
conrm operation