What to do if there is a dry fire in my Vaillant ecoTEC exclusive 832 Boiler?
If there is a dry fire in your Vaillant Boiler, it could be due to too little water in the appliance, a defective water shortage switch, a defective cable to the pump or water shortage switch, a blocked or defective pump, or the pump output being too low. Contact the service team for assistance.
What to do if there is a water shortage and the temperature rise is too quick in my Vaillant ecoTEC exclusive 832?
If there is a water shortage and the temperature rise is too quick in your Vaillant Boiler, it may be caused by a blocked pump, low output from the pump, air in the appliance, or the system pressure being too low. Contact the service team for assistance.
What does it mean if the safety temperature limiter is actuated on my Vaillant ecoTEC exclusive 832?
If the safety temperature limiter is actuated on your Vaillant Boiler, it could be because the flow probe is not connected thermally correct or is defective, or the appliance does not shut down. Contact the service team for assistance.
What causes speed deviation in the fan of a Vaillant ecoTEC exclusive 832 Boiler?
Speed deviation in the fan of your Vaillant Boiler can be caused by the fan being blocked, the plug not being inserted correctly on the fan, a defective hall sensor, a fault in the cable harness, or defective electronics. Contact the service team for assistance.
What does it mean if there is no sudden change in pressure detected on turning on the pump in my Vaillant ecoTEC exclusive 832 Boiler?
If no sudden change in pressure is detected when turning on the pump in your Vaillant Boiler, it could indicate a defective water pressure sensor or pump. Other potential causes include too little water in the appliance, issues with the adjustable bypass, the expansion vessel not connected in return, or air in the appliance. Contact the service team for assistance.
General safety instructions and regulations to be observed.
Procedures to follow in case of a gas leak.
Procedures to follow in case of flue gas smell.
Detailed instructions and safety warnings for connecting the gas supply.
Instructions for connecting the hot and cold water supply pipes.
Steps for connecting the heating flow and return pipes.
Instructions for fitting the air/flue gas duct and available components.
Instructions for filling the heating system and conditioning the water.
Steps for filling and venting the boiler and the entire heating system.
Procedure for checking and adjusting the CO2 concentration for optimal combustion.
Essential safety precautions before replacing any component.
To Next Page
General