To Next PageTo Next Page
Need help?Do you have a question about the Vaillant ecoTEC plus 1006 VU GB 1006/5-5 and is the answer not in the manual?
General| Efficiency | 94% |
|---|---|
| Fuel Type | Natural Gas |
| Dimensions (H x W x D) | 720x440x338mm |
| ErP Rating | A |
| Central Heating Flow Temperature Range | 30°C - 80°C |
| Maximum Working Pressure | 3 bar |
| Warranty | 5 Years |
| Boiler Type | Combi |
Classification of action-related warnings by severity using warning signs and signal words.
Product is intended as a heat generator for closed heating installations and hot water generation.
Covers risks like inadequate qualifications, flue gas, electric shock, burns, and material damage.
Specifies the required spatial clearances for installation and maintenance.
Describes procedures for wall-mounting the product based on wall conditions.
Covers essential steps and precautions for performing the gas installation.
Details the procedures for connecting the product's hydraulic components.
Provides instructions and regulations for installing the flue gas system.
Guides on connecting the product to the electrical power supply and wiring.
Explains the product's operating concept and installer-level settings.
Instructions for performing the initial start-up procedure by a service technician.
Guidance on checking and treating heating water and filling the system.
Details on using the installation assistants for initial setup and configuration.
Detailed steps for filling and purging the heating installation system.
Procedure for correctly filling the condensate trap to prevent gas escape.
Steps for checking and adjusting the gas ratio setting for optimal combustion.
Procedures for checking the leak-tightness of gas, heating, and hot water circuits.
Emphasizes adherence to inspection and maintenance intervals for safety.
Information on what details to provide when contacting a service partner.
How to interpret service messages and read fault codes from the display.
Accessing and interpreting the product's fault memory and performing diagnostics.
Steps for resetting parameters and preparing the product for repair work.
Detailed guides for replacing various defective components of the product.
List of fault codes, their meanings, and likely causes.
Checklist for competent persons to ensure correct initial start-up.
Checklist for commissioning the boiler according to Building Regulations.
