Need help?Do you have a question about the Vaillant ecoTEC plus 840 and is the answer not in the manual?
Conveys important safety information to prevent risks of death, injury, or damage.
Details various safety devices like electrical supply failure, overheating, frost protection, and condensate blockage.
Outlines the comprehensive steps required for installing the product.
Covers essential preparations before installation, including gas and water supply checks.
Covers the installation of the air/flue pipe system, including notes on room-sealed installations.
Explains how to install the gas pipe, including using the gas isolation valve.
Explains how to install the condensate discharge pipe and siphon.
Outlines the procedures and safety precautions for electrical installation.
Provides specific safety instructions for installing the product in a moist environment.
Covers the operation of the product.
Explains how to access the installer level using a specific code.
Guides on accessing, selecting, and setting diagnostics codes.
Details how to run the chimney sweep mode for combustion analysis.
Covers the initial start-up procedures and checks.
Provides a checklist to be completed before powering on and commissioning the boiler.
Guides on performing the initial start-up procedure using the Benchmark Checklist.
Explains how to check and treat heating water quality and filling water.
Guides on using the installation assistant for initial product setup.
Explains how to ensure correct system pressure, considering static height.
Provides step-by-step instructions for filling the heating installation with water.
Explains how to purge air from the heating installation.
Lists technical tests required for gas settings before operation.
Covers adjusting the unit's settings to suit the specific installation.
Details how to adjust settings related to heating mode operation.
Covers adjusting settings for domestic hot water operation.
Outlines the final steps for handing over the installed product to the end user.
Covers routine inspection and maintenance procedures.
Explains how maintenance intervals are defined and set.
Details annual inspection requirements and checks to be performed.
Provides detailed instructions for removing and installing the compact thermal module.
Provides guidance on identifying and resolving product issues.
Explains fault messages displayed when errors occur.
Provides steps to eliminate faults, including a reset procedure.
Covers the process of replacing defective components.
Provides a table of manufacturer requirements for minimum inspection and maintenance intervals.
Lists and explains fault codes that indicate errors or problems.
Provides a checklist for commissioning the boiler and validating the warranty.
To Next Page
General