Need help?Do you have a question about the Vaillant VWL 57/5 IS and is the answer not in the manual?
General| Type | Air-to-water heat pump |
|---|---|
| Heating capacity | 5.7 kW |
| Energy Efficiency Class (Heating) | A++ |
| Energy Efficiency Class (Cooling) | A+ |
| Refrigerant | R410A |
| Noise Level (Indoor Unit) | Not applicable (outdoor unit) |
| Weight (Indoor Unit) | Not applicable (outdoor unit) |
| Dimensions (Indoor Unit) | Not applicable (outdoor unit) |
Classification and explanation of warning signs and signal words.
Defines the product's purpose and allowed combinations.
Covers risks from qualifications, weight, safety devices, electric shock, installation surface, and malfunctioning.
Explains functions like frost protection, low-water pressure, freeze protection, and pump blocking.
Describes the display elements and their functions.
Defines operating limits for heating, DHW and cooling modes.
Details how to set the domestic hot water temperature safely.
Explains how to check and maintain correct heating circuit pressure.
Covers frost protection, summer mode, and DHW generation shutdown.
How to interpret maintenance indicators and comfort protection mode.
Details how to check and maintain system pressure.
Explains how fault messages are displayed and prioritized.
Guidance on checking and resolving issues using a table.
Criteria for choosing a suitable installation location.
Specifies required space around the unit for access and safety.
Pre-installation steps including component installation and system flushing.
Guidance on handling and routing refrigerant pipes.
Detailed steps for connecting refrigerant pipes safely.
Procedures to ensure the refrigerant circuit is leak-tight.
Safety precautions and requirements before electrical work.
Guides through connecting power supply for 230V and 400V systems.
Instructions for connecting external controls for power limitation.
General instructions for performing wiring tasks safely.
Procedure for activating screed drying function without external controls.
Steps to activate and configure the screed drying process.
Detailed steps for filling and purging the heating system.
Basic steps to start the heat pump system after installation.
Guides through setting language, competent person number, and ending the assistant.
How to activate and set the output for the electric back-up heater.
How to configure the anti-legionella function for safety.
How to test individual components for proper function.
Steps to check heating water quality and identify issues.
How to measure the hardness of filling and supplementary water.
Guidelines for treating heating water based on hardness and regulations.
How to adjust parameters after initial installation.
Key information to provide to the end user for safe operation.
How to check and interpret fault codes displayed by the product.
Defines inspection and maintenance goals and procedures.
How to check and top up heating water pressure.
Provides a table of installer-level settings and parameters.
Lists and explains various status codes displayed by the product.
Explains codes and causes for maintenance messages.
Lists and explains various fault codes and their remedies.
Lists required inspection and maintenance tasks with intervals.
To Next Page