2. Insert the probe connection cable in one of the ports on the bottom of the indicator.
• Note the orientation of the cable connector when inserting it
• Hold the connector in place while turning its locking ring clockwise –
never twist the connector body!
3. Connect the probe to the M12-5F end of the probe connection cable.
When the indicator recognizes the connected probe, it shows a notification on the display
(for example, GMP252 connected). A probe connected to the leftmost port in the
indicator is labeled
on the indicator's display, while the probe in the rightmost port is
labeled .
4. To change probes, simply detach the cable from the probe and connect a new probe.
9
ENGLISH
To Next Page
Loading...
