14. Look at the display:
• If dashes "- - -" are shown instead of measurement readings, check that the probe and
probe splitter are properly connected. It is possible to disconnect the probe splitter
accidentally by pulling it with the battery cover open.
• Battery indicator should show full batteries .
• There should be no error codes shown. If there are, see Error codes (page 23).
15. Close the battery cover of the data logger. Push the latch down until you hear a click. If
the cover does not close easily, push the probe splitter in and try again.
Once the data logger has been set up for two temperature probes using the
probe splitter, it requires a factory reset before it can be set up for one-probe
mode or operation with a CO
2
probe.
For the factory reset procedure, see RFL100 User Guide (M211861EN).
Setup with CO₂ probe
1 DC power supply with micro-USB connector
2 Power supply connection to service port
3 Electronics housing of the Probe Splitter M8/M12 accessory and its magnetic holder
4 Humidity or temperature probe
5 M8 connector of the probe splitter
6 GMP251 CO
2
probe
7 Probe support accessory
8 M12 connector of the probe splitter
9
ENGLISH
To Next Page
Loading...
