INSTATALLATION - LOCATION SITE
This Val Therm water heater can be installed either inside or outside. We
strongly recommend sheltered from rain. It is important that all safety and
installation standards be respected.
The water heater must be positioned vertically and at the filter end. A free space
of 12’’ all around the heater must be accessible for maintenance.
ELECTRICITY
The electrical wirings must be performed by qualified electrician.
PLUMBING
The inlet and outlet of the pool heater are connected to two 1 ½” N.P.T. threaded
cap is included with all models for emptying convenience.
Note: Use only Teflon tape to assure water tightness of pipes connections.
Tight pipes properly, and use tools when necessary, ex: Pipe wrench.
To Next Page
Loading...