22 23
FR FR
Aperçu de l’appareil Aperçu de l’appareil
A A
22 23
EN EN
Useful information Note
C
Problem Possible cause and solution
The motor
is running
continuously.
It is normal to hear the motor noise regularly. It will need to run
more in the following circumstances:
• The temperature setting is colder than necessary.
• A large quantity of hot food has recently been placed in the
appliance.
• The temperature outside the appliance is too high.
• The doors have been opened too often or for too long.
• After installing your appliance or if it has been switched off for
an extended period.
A layer of frost
has formed in the
compartment
Make sure that the food placed in the appliance allows sufficient
ventilation. Check that the door is closed. To remove the frost,
please refer to the “Cleaning and maintenance” section.
The temperature is
too high
You may have opened the doors too often or for too long, or the
correct closing of the doors may be impeded by an obstacle. There
may also be insufficient clearance at the sides, back and top of the
appliance.
The interior
temperature is too
low
Increase the temperature according to the instructions in the
“Operation” section.
Doors have trouble
closing
Check that the top of the refrigerator is tilted back 10-15 mm to
allow the doors to close automatically and ensure that nothing
inside the appliance is preventing the doors from closing.
Water is leaking
onto the floor
The water tank (located at the bottom and rear of the appliance)
may not be properly levelled or the drain nozzle (located under
the top wall of the compressor) may not be correctly positioned to
direct water into the tank. It is also possible that the water drain
is clogged. You may need to move the fridge away from the wall to
check the tank and nozzle.
The lighting does
not work
The lightbulb may be damaged. To replace the lighting, please
refer to the “Operation” section.
To Next Page
Loading...
Need help?
General
