37
EN
Useful information
C
PROBLEM POSSIBLE CAUSE TROUBLESHOOTING
Some food waste
remains on the
dishes.
The dishes were not placed
correctly and the water spray
could not reach the affected
areas.
Do not overload the racks.
The dishes are leaning against
each other.
Place the dishes as indicated in the
section on loading your dishwasher.
Not enough detergent used.
Use the correct amount of detergent
as indicated in the programme table.
Incorrect wash programme
selected.
Use the information in the programme
table to select the most suitable
programme.
Spray arm clogged with food
remains.
Clean the holes in the spray arms with
thin objects.
Dirty filters or drain pump, or
improperly installed filters.
Check that the drain hose and filters
are correctly installed.
Whitish stains
remain on the
dishes.
Not enough detergent used.
Use the correct amount of detergent
as indicated in the programme table.
Rinse aid and/or water
softener dosage too low.
Increase the level of rinse aid or water
softener.
High level of water hardness.
Increase the water softener level and
add salt.
The salt compartment is not
closed properly.
Check that the salt compartment cap
is tightly closed.
Dishes do not dry.
The drying option is not
selected.
Select a programme with a drying
option.
The dose of the rinsing aid is
too low.
Increase the rinse aid dose setting.
To Next Page
Loading...
