28
EN
Using the appliance
B
WATER HARDNESS
Water
softner level
Regeneration
occurs every
X program
sequence
1)
Salt
consumption
(gram/cycle)
German
dH
French
fH
British
Clarke
Mmol/l
0 - 5 0 - 9 0 - 6 0 - 0,94 H1 No regeneration 0
6 - 11 10 - 20 7 - 14 1,0 - 2,0 H2 10 9
12 - 17 21 - 30 15 - 21 2,1 - 3,0 H3 5 12
18 - 22 31 - 40 22 - 28 3,1 - 4,0 H4 3 20
23 - 34 41 - 60 29 - 42 4,1 - 6,0 H5 2 30
35 - 55 61 - 98 43 - 69 6,1 - 9,8 H6 1 60
1°dH=1.25 °Clarke=1.78 °fH=0.178mmol/l
The factory setting: H3
1)
Every cycle with a regeneration operation consumes additional 2.0 litres of water, the
energy consumption increases by 0.02 kWh and the program extents by 4 minutes.
NOTE
Please check the “Loading The Salt Into The Softener”, if
your dishwasher lacks salt.
NOTE
If your model does not have any water softener, you may
skip this section.
Water Softener
• The hardness of the water varies from place to place. If
hard water is used in the dishwasher, deposits will form
on the dishes and utensils.
• The appliance is equipped with a special softener that
uses a salt container specifically designed to eliminate
lime and minerals from the water.
To Next Page
Loading...
