14
B
Installation
• Noise, excessive vibrations and water leakages can be caused by incorrect installation.
• Never move the appliance by lifting it by the worktop.
• Read this «installation guide» before operating.
• Keep this «installation guide» for future reference.
• Read the general recommendations about disposing of packaging in the instruction for use.
Before using the washer, please remove transport bolts!
IMPORTANT
Transport bolts which are not removed can cause damage
to the appliance.
1
Screw off all transportation bolts for approx. 30mm with wrench following the direction of
arrow shown (not fully screw it off).
30
2
Push four transportion bolts on horizontal direction inward and loose transportation bold.
Using the appliance
EN
15
B
3
Pull out transportation bolt together with rubber part and plastic part.
4
To ensure safety and reduce noise, you should install the transportation bolt cover supplied
with the unit (see the annex accompanying the unit). Lean and place the transportation bolt
into hole and press it following the shown direction until it clicks.
IMPORTANT
Keep the transport bolts and the wrench for future
transporting of the appliance and in this case refit the
transnort bolts in reverse order.
Using the appliance
EN
To Next Page
Loading...
Need help?
General