EasyManuals Logo

VALBERG WF 612 D DS701T User Manual

VALBERG WF 612 D DS701T
150 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
5 EN
Using the appliance
B
Installation
Removing the transit bolts
X4
X4
1
3
X4
2
4
Before using the washing machine, remove the 4 transit bolts and rubber washers located
at the rear of the machine. Failure to comply with this instruction may cause strong vibrations, a
high level of noise and damage to the machine, rendering the warranty null and void.
Loosen the transit bolts by turning them anticlockwise with a suitable spanner.
Remove the transit bolts by pulling them straight out.
Fit the plastic blanking plugs supplied with the accessory kit on the holes left once the transit
bolts have been removed. Keep the transit bolts for later use.
NOTE
Remove the transit bolts before using the machine for
the first time. Faults resulting from a machine used
with the transit bolts still attached are not covered
by the warranty.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the VALBERG WF 612 D DS701T and is the answer not in the manual?

VALBERG WF 612 D DS701T Specifications

General IconGeneral
BrandVALBERG
ModelWF 612 D DS701T
CategoryWasher
LanguageEnglish

Related product manuals