43 EN
Useful information
C
Fault Possible cause Troubleshooting
Your machine vibrates.
The feet have not been
adjusted.
Adjust the feet. (**)
Transit bolts tted for
transportation have not been
removed.
Remove the transit bolts from
the machine. (**)
Small load in the drum.
This will not prevent operation
of your machine.
Your machine is overloaded
with laundry or laundry is
unevenly spread.
Do not overload the drum.
Spread laundry evenly in the
drum.
Your machine rests on a hard
surface.
Do not set up your Washing
Machine on a hard surface.
Excessive foam is formed
in the detergent drawer.
Excessive amount of detergent
used.
Press the Start/Pause button.
To stop the foam, dilute one
tablespoon of softener into 1/2
litre of water and pour into the
detergent drawer. Press the
Start/Pause button after 5-10
mins.
Wrong detergent used.
Only use detergents produced
for automatic Washing
Machines.
Unsatisfactory washing
result.
Your washing is too dirty for
the programme selected.
Use the information in
the programme tables to
select the most appropriate
programme.
Amount of detergent used
insucient.
Use the amount of detergent
as instructed on the packaging.
There is too much laundry in
your machine.
Check that the maximum
capacity for the selected
programme has not been
exceeded.
Unsatisfactory washing
result.
Hard water.
Increase the amount of
detergent following the
manufacturer’s instructions.
Your laundry is too tightly
packed together in the drum.
Check that your laundry is
spread out.
As soon as the machine is
loaded with water, water
discharges.
The end of water drain hose is
too low for the machine.
Check that the drain hose is at
a suitable height. (**) .
No water appears in the
drum during washing.
No fault. Water is in the
unseen part of the drum.
/
Laundry has detergent
residue.
Non-dissolving particles of
some detergents may appear
on your laundry as white spots.
Perform an extra rinse, or
clean your laundry with a
brush after it dries.
To Next Page
Loading...
Need help?
General