What causes the front-panel scanner indicator not to turn off on Valco Cincinnati Controller?
If the front-panel scanner indicator on your Valco Cincinnati Controller does not turn off, ensure that the scanner is not too close to a machine element.
How to adjust delay if it is too short or too long at high speed on Valco Cincinnati VC3700 Controller?
If the delay is too short or too long before the pattern begins at high speed on your Valco Cincinnati Controller, make sure that the delay value has been correctly entered. Also, verify that the delay is correct at low speed and that the turn-on compensation has been correctly entered.
What to check if pattern length is too short or too long at high speed on Valco Cincinnati VC3700?
If the pattern length is too short or too long at high speed on your Valco Cincinnati Controller, ensure that the pattern value has been correctly entered. Also, verify that the pattern length is correct at low speed and that the turn-off compensation has been correctly entered.
General| Brand | Valco Cincinnati |
|---|---|
| Model | VC3700 |
| Category | Controller |
| Language | English |
Lists critical safety warnings for installation and operation.
Covers mechanical mounting and electrical wiring for the main control unit.
Details for installing both wheel-driven and gear-driven encoders.
Procedures for positioning and electrically connecting product scanners.
Instructions for connecting glue valves to the control system.
Setting the minimum speed required for gluing to begin.
Defining the distance between the scanner and glue valve.
Adjusting encoder input for accurate speed measurement.
Configuring valve turn-on and turn-off times.
Step-by-step guide to setting up and configuring a new job.
Instructions for saving current job parameters for future use.
Procedure to recall and activate previously saved jobs.
Selecting how scanners are used for product detection.
Choosing between single or dual delay/pattern modes.
Setting the timing and length for glue application.
Defining the product length for jam detection and lockout.
Addresses issues with front panel lights, touchscreen, and power indicators.
Solutions for scanner indicator not illuminating or staying on.
Troubleshooting for encoder indicator and speed display issues.
Addresses issues with valve indicator lights and glue dispensing.
Solutions for incorrect delay or pattern length at different speeds.
Troubleshooting for issues with the glue inspection system PASS light.
General terms and conditions of the product warranty.
Warranty period for cold-glue equipment and electronic controls.
Information on how to contact Valco for service and support.
Procedures for sending data from a host computer to the control.
Procedures for receiving data from the control to a host computer.
To Next Page