Valcom PagePac 6 Plus - Setting System Options via Dial Codes

7947182
Setting Options
To select the desired option, dial the code shown.
1. Pick up the telephone and listen for PagePac 6 Plus dial tone
(on key systems, select the desired line first).
2. Dial the number for the option desired (see Table 2 or the simplified user guide supplied), and listen
for program tone (two short tones).
3. Replace the receiver.
Note: If you hear reorder tone (fast busy tone), a dialing error has been made. Hang up and start over.
Table 2 is also on the bottom of the PagePac 6 Plus chassis.
Table 2. Programming Options
Option Dial Code
Confirmation tone - OFF*
Confirmation tone - ON
834
835
Music in Zone 1 - ON
Music in Zone 2 - ON
Music in Zone 3 - ON
Music in all zones - OFF*
811
812
813
814
Talkback on Line 1 - OFF
Talkback on LIne 2 - OFF
Talkback on Lines 1 and 2 - ON*
891
892
893
Talkback in Zone 1 - OFF
Talkback in Zone 2 - OFF
Talkback in Zone 3 - OFF
Talkback in all zones - ON*
821
822
823
824
Initial talkback Warning Tone - OFF**
Repetitive talkback Warning Tone - OFF*
Both talkback Warning Tones - ON*
Time between Repetitive tones - 15 seconds
Time between Repetitive tones - 30 seconds*
831
832
833
841
842
All-zone paging - OFF
All-zone paging - ON*
851
852
Automatic Outside Line Access
LINE 1
OFF
2 sec.
4 sec.*
10 sec.
861
862
863
864
LINE 2
OFF
2 sec.
4 sec.*
10 sec.
865
866
867
868
* Indicates the default or factory-set condition for each option. If power goes off, all
options are reset to their default values.
** Check local regulations before shutting off either the Initial or Repetitive
talkback warning tones.
Technical Manuals Online! - http://www.tech-man.comTechnical Manuals Online! - http://www.tech-man.com
firealarmresources.com