Valcom VIP-801 Quick Guide

1 947995
ISSUE 3
VIP-801
NETWORKED PAGE ZONE EXTENDER
INTRODUCTION
The VIP-801 Networked Page Zone Extender
enables voice access to a single zone of one-way
paging over an IP-based LAN/WAN. This allows
page zone extension anywhere on the network.
SPECIFICATIONS
Features
• 1 Audio Input
• 1 Audio Output
• 2 Form C Relays
• 1 Contact Closure Input
• RJ-45 for network connection
• Front panel activity LED
• Provides audio for up to 150 Valcom one-way
amplified speaker assemblies
• AUX audio input via RCA jack
• Contact closure or VOX operation of audio input
• Removable screw terminal connectors provided
for audio and relay interface
• Page with music output, music mutes during
page
• Output control contact closure provided during
paging output
• Compatible with 25 or 70 Volt amplifiers
• 2.5mm jack for DC power
• Power over Ethernet 802.3af Compliant
Dimensions/Weight
• 1.38 H x 6.13" W x 5.25" D
(3.50cm H x 15.6cm W x 13.33cm D)
• Weight: 1.25 lbs. (0.57 kg)
Nominal Specifications
Input Impedance: 600 Ohms
Input Level: -10dBm nominal
Voice Switch Sensitivity: -21dBm
Music Source Input Impedance: 8 to 600 Ohms
Music Input Level: -10dBm nominal
Output Impedance: 50 Ohms
Output Level: - 10dBm nominal
Relay Current: 1 Amp @ 24VDC
Nominal Power Requirements
Via rear panel barrel connector:
Voltage: 24VDC
Current: 325mA
Via 802.3af PoE Ethernet Switch:
802.3af: Class 3
Environment
Temperature: 0 to +40° C
Humidity: 0 to 85% non-precipitating
Packing List
INSTALLATION
FCC Information
This equipment has been tested and found to
comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference when
the equipment is operated in a commercial
environment. This equipment generates, uses
and can radiate radio frequency energy and if
not installed and used in accordance with the
instruction manual, may cause harmful
interference to radio communications.
Operation of this equipment in a residential area
Qty Item
1 VIP-801
1 VIP Setup CD
1 VSP Document
2 Mounting Brackets
4 Rubber Feet
6 Wood Screws
1 RJ-45 Patch Cable

Valcom VIP-801 Specifications

General

Form factor	Box
Rack mounting	No
Connector type	RJ-45
Supported network protocols	DHCP, IGMP v3, UDP, TCP, HTTP, Telnet, FTP
Compliance industry standards	802.3af
Number of voice channels supported (max)	1
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	0 - 85 %

Weight and Dimensions

Depth	133.3 mm
Width	156 mm
Height	35 mm
Weight	562.5 g