Note: It is advised to follow the below configuration to prevent having to adjust left and right plate
settings in the ForceDecks software.
The ForceDecks system consists of a ‘Primary’ plate and a ‘Secondary’ plate.
It is important to ensure cables between the plates and power source are routed to prevent them
being stepped on or caught underneath the plate, as this can cause instability, potentially affect
measurements and/or damage the cables.
4.6 Battery
Each ForceDecks plate contains a rechargeable battery. The battery life and recharge times are as
follows:
If it recommended to connect ForceDecks plates to a power source for at least one full day every
month, as the batteries will slowly discharge over time when not in use.
To Next Page
Loading...