© 2019 Valeport Ltd
Communications
Page 13
5.2.6. Information #Codes
The following commands will cause the sensor to report back various pieces of information, as described:
Year of manufacture, month and year of last inspection/service
Maximum transducer pressure range
Outputs a full list of all command codes applicable to the sensor.
Note that not all of these codes are covered by this manual – use this feature with care.
5.2.7. Calibration
The miniIPS may be returned to Valeport or one of its approved laboratories for recalibration, or it may be re-
calibrated by the customer using a Class A deadweight tester, or defined standard of the customer’s choosing.
To Next Page
Loading...
