5
Basic Tutorial for LOOP 1 and 2
Basic Tutorial for LOOP 1 and 2
LOOP footswitch indicator color
Empty LOOP does not light up
• The red light is always on when the bottom track is recording
• The green light is always on when playing
• The blue light is always on when overdubbing
• The blue light will ash slowly while waiting for overdubbing to be completed in
integer multiples
• When stopped, the white light remains steady
• Yellow light ashes after selected loop is waiting to play in SERIAL mode
• The red light ashed 3 times after delete the loop
• The blue light ashes after undo a recording
• The green light ashes after redo a recording
Record, Play, Overdub and Delete
Recording
bottom track
Play Overdub Play
Play
Stop Delete Loop
Press Press Press
Press Twice
x2
Press
Press
Hold
“Bottom track”: The rst recorded track of a blank LOOP.
“Overdub”: Overlay the second and subsequent recordings on top of the bottom track
“Stop”: Press twice to stop the LOOP only active when the LOOP is playing.
"Delete": When there is only the bottom track recorded, a long press during playback
will directly delete the base track. If the recording includes overdubs, you can use a
combination of (single press + long press) to quickly delete the entire track.
Additional Tips
:
long-pressing the MEMORY/SAVE encoder allows you to switch the
current recording mode between Manual Recording (MR) and Automatic Recording
(AR). When switched to Automatic Recording, the current LOOP will automatically start
recording upon detecting a certain level of signal input after pressing the footswitch.
To Next Page
Loading...