4. Re-install the Top Rail bolts previously removed
5. Install (2) Rubber Grommets in each of the Side Shields, from the outside
6. Install the Center Shield by aligning it with the two holes in each Side Shield and assemble
using (4) each of the bolts and nuts, as well as (8) Washers.
Remove the Access door from the side of the table and feed the power cord through the hole in the
bottom of the table. Secure the metal plate into the bottom.
Plug the Powercord into a suitable outlet and switch the On/Off Switch to the On position.
Programming Instructions are listing on the Access Door. For
Parts and Technical information, please visit our website at
www.valley-dynamo.com or call 972-595-5300
To Previous Page
Loading...
