Side Shield Installation
The Side Shield kit contains the following:
(2) Side Shields
(1) Center Shield
(18) Rubber Grommets
(4) ¼-20 x 1” Black Oxide Hex Bolts
(4) Lock nuts
(8) ¼” Black Oxide Washers
1. Remove the bolts from the Side Top Rail. It is not necessary to remove the bolt at the very
end of each Side Rail.
2. Insert Rubber Grommets into the holes from the top of each Side Shield
3. Align the Side Shield over the LED light strip, so that the lighting is inside the groove of Side
Shield. Please note that the flange of the Shields go to the outside.
To Next Page
Loading...
