SETUP WIZARD
EXPERT SETTINGS
PROFILE SETTINGS
The following sections describe how to make ventilation settings for
the system profiles.
AT HOME PROFILE
To make the At home profile settings, proceed as follows:
1. The setup wizard for At home profile opens.
NOTE
Once you have set the basic ventilation air flow rates, the higher
percentage value will by default be set to the At home profile fan
speed value. It is recommended that this basic ventilation setting
be used for the At home profile. However, the setting can be
changed as required.
2. Use the Plus and Minus buttons to set the At home profile
fan speed as a percentage of the maximum output ratio.
3. The At home profile fan speed value is now set.
4. Press the Right arrow button.
5. The temperature setup opens.
6. Set the desired supply air temperature for the At home profile
by using the Plus and Minus buttons. You can adjust the
temperature in the range +10°C ... +25°C.
7. The At home profile supply air temperature is now set.
8. Press the Right arrow button.
9. The setup for automatic fan speed control based on the
relative humidity opens.
10. Use the Plus and Minus buttons to select whether the
automatic fan speed control, based on the relative humidity
of air, is used or not.
11. The automatic fan speed control, based on the relative
humidity of air, is now set.
12. Press the Right arrow button.
13. The setup for automatic fan speed control based on the
carbon dioxide level opens.
14. Use the Plus and Minus buttons to select whether the
automatic fan speed control, based on the carbon dioxide
level, is used or not.
15. The automatic fan speed control, based on the carbon
dioxide level, is now set.
16. Press the OK button.
To Next Page
Loading...
