Page 8 of 14
GEN2-V1 12ft-Instructions (Severe Weather) doc:r1
AWNING OPERATION:
Your Awning has been configured for LEFT Side operation (when facing the wall). Remove the LEFT WALL
BRACKET, and the RIGHT WALL BRACKET from their individual boxes. Neither bracket will have their ROLLER
TUBE SUPPORT BRACKET or Gear Mechanism attached. Inside the RIGHT WALL BRACKET box will be the as
well as the ROLLER TUBE SUPPORT BRACKET and a PLASTIC BUSHING. Locate the box labeled GEAR MECH.
w/Roller Tube Support Bracket, and Mount the ROLLER SUPPORT BRACKET, which already has the GEAR
Mechanism mounting to it on the end of the Square 40x40mm Torsion Bar. Leave the ROLLER TUBE SUPPORT
BRACKET off of the RIGHT WALL Bracket.
Lay your LEFT and RIGHT BRACKET ASSEMBLIES on the ground as shown in the diagram below.
Left Side operation:
CONVERT TO RIGHT SIDE OPERATION:
Should you wish to convert your Awning to a RIGHT side operation; this can be done by following the configuration
steps below:
1. Leave your RIGHT & LEFT WALL BRACKET ASSEMBLIES, layed out as shown above.
2. Remove the ROLLER SUPPORT BRACKET which has the GEAR Mechanism mounting to it, from the LEFT
WALL BRACKET ASSEMBLY.
3. Remove the three Allen bolts that are securing the GEAR MECHANISM to the support bracket and move it
to the opposite side of the ROLLER SUPPORT BRACKET; DO NOT TRY TO MOUNT THE GEAR
MECHANISM TO THE OTHER ROLLER TUBE SUPPORT BRACKET AS ITS MOUNTING HOLES MAY
NOT ALIGN.
4. Install the ROLLER TUBE SUPPORT BRACKET with the GEAR MECHANISM mounted to it on the RIGHT
WALL BRACKET ASSEMBLY, AS SHOW IN THE DIAGRAM BELOW.
5. The remaining ROLLER TUBE SUPPORT BRACKET will now be mounted on the LEFT WALL BRACKET
ASSEMBLY, however the PLASTIC BUSHING will now be removed and pressed in to the hole on the
Support Bracket from the inside of the bracket, as shown in the diagram below.
6. The last step will now be adjusting the position of the Right & Left EXTENSION ARM SHOULDER
BRACKETS to switch the clearance for the GEAR MECHANISM moved to the opposite side.
7. DO NOT loosen bolts on the Wall Brackets, However loosen the two Allen bolts holding the Right & Left
EXTENSION ARM SHOULDER BRACKETS, and move them to the location shown below. Re-tighten the
two Allen bolts on both
Should you have difficulty with this please call our customer service department at
1-888-875-4844, and we can walk you through this process.
LEFT WALL BRACKET ASSEMBLY
RIGHT WALL BRACKET ASSEMBLY
To Next Page
Loading...