Valtir.com 3 Revision F August 2022
Customer Service Contacts
Valtir is committed to the highest level of customer service. Feedback regarding the QuadGuard
®
M10, its assembly procedures, supporting documentation, and performance is always welcome.
Additional information can be obtained from the contact information below:
Valtir
Telephone
(888) 323-6374 (USA)
+1 312 467-6750 (International)
Contact Link Valtir.com/Contact
Important Introductory Notes
Proper assembly of the QuadGuard
®
M10 is critical to achieve tested performance that has been
evaluated and deemed eligible by the FHWA per AASHTO MASH criteria. These instructions
should be read and understood in their entirety before assembly. These instructions are for
standard assemblies and used in conjunction with the assembly of the QuadGuard
®
M10 as
specified by the applicable highway authority. If you need additional information, or have
questions about the QuadGuard
®
M10, please contact the highway authority that has planned
and specified this assembly and, if needed, contact Valtir. This product must be assembled in the
location specified by the appropriate highway authority. If there are deviations, alterations, or
departures from the assembly protocol specified in this manual, the device may not perform as
tested.
Important:
DO NOT use any component part that has not been specifically
specified herein for the QuadGuard
®
M10 during the assembly or repair of this
system (p. 7 – 10 / 38 - 39).
This product has been specified for use by the appropriate highway authority and has been
provided to that user who has unique knowledge of how this system is to be assembled. No
person should be permitted to assist in the assembly, maintenance, or repair of this system that
does not possess the unique knowledge described herein. These instructions are intended for
an individual qualified to both read and accurately interpret them as written. These instructions
are intended only for an individual experienced and skilled in the assembly of highway products
that are specified and selected by the highway authority.
A manufacturer’s drawing package will be supplied by Valtir upon request. Each system will be
supplied with a specific drawing package unique to that system. Such drawings take precedence
over information in this manual and shall be studied thoroughly by a qualified individual who is
skilled in interpreting them before the start of any product assembly.
To Next Page