Pressure
bar x 14.504 psi
psi x 0.0690 bar
Flow rate
l/min x 0.2642 gal/min (US)
gal/min (US) x 3.7853 l/min
l/hr x 0.2642 gal/hr (US)
gal/hr (US) x 3.7853 l/hr
l/ha x 0.1069 gal/acre (US)
gal/acre (US) x 9.3531 l/ha
Speed
kph x 0.6214 mph
mph x 1.6093 kph
Weight
g x 0.03527 oz
oz x 28.3495 g
kg x 2.2046 lb
lb x 0.4536 kg
t x 1.1023 US ton
US ton x 0.9072 t
Temperature
°C (°C x 1.8) + 32 °F
°F (°F - 32)/1.8 °C
1.1.4 Tightening torques
1.1.4.1 Tightening torques for screws and nuts
Use the tightening torques recommended for screws and nuts according to the tables below:
• 1 and 2 for metric threads
• 3, 4, 5 and 6 for threads in inches
When a specific torque is required, this is stated in the text.
Tables 1, 3 and 5 indicate the normal tightening torque values to apply to threaded zinc-plated elements,
with normal nuts, coarse or fine threads, and with or without a flat washer or lock washer, and weldable
nuts with a height greater than or equal to 0.8 d.
[V]
GUID-B41C8DED-9F9B-4553-BACC-7AB42E5CB543 [V1]
1. Introduction
1-16
ACX2831410
To Next Page
Loading...
