--- 1 7 ---
C. General description
available.
The front power take---off is available as extra equipment
(with front linkage). The front PTO shaft nominal rotating
speed is 1000 r/min and the shaft is 6---spline.
C5. Brakes
NC30
The oil bath multi---disc brakes are located on the rear
axle between the differential and final drives. The brakes
operate hydraulically from the brake pedals. When both
brake pedals are depressed the front wheel drive is en-
gaged automatically in order to provide braking function
at the front wheels. The pedals can be connected together
and used as running brakes or separated and used indi-
vidually as steering brakes. The brakes can be adjusted
by means of adjusting nuts which are fitted on the rear
axle.
The parking brake is electro---hydraulic and is controlled
with a shuttle lever. When engaging the parking brake, the
pressure exhausts from the cylinder operate the parking
brake and a strong spring engages the tractor brakes. At
the same time the control unit disengages the trans-
mission. With this system the tractor brakes are always on
when the engine is not running.
Atrailerbrakevalveandtheairpressurebrakesareavail-
able as extra equipment.
To Next Page
Loading...
Need help?
General
