EasyManuals Logo

Valtra T195 CVT User Manual

Valtra T195 CVT
31 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #30 background imageLoading...
Page #30 background image
Starting assistance
WARNING:
Never use any starter fluid or aerosol
sprays.
This could cause an explosion and very serious
injuries.
GUID-3C9BC39A-A890-4043-8775-CDAD4D2107E9-high.jpg [High]
Fig. 8
2.7.3 Starting the tractor with jump start cables
IMPORTANT:
Do not attempt to boost a damaged battery.
Do not touch the connectors on the jump start cables.
Do not allow your body to touch the vehicle (chassis frame) when making the connections.
Do not use a damaged battery or a damaged booster.
Only use a battery or a booster with a similar voltage.
To avoid accidental hazards when working near the battery, remove all jewellery or metal accessories,
such as rings or bracelets.
Do not disconnect the damaged battery — this can damage the vehicle's electrical system.
Procedure
1. The ignition key must be in the OFF position.
ATTENTION:
The tractor engine must not start up or move accidentally.
2. Connect the clamp of the red cable to the positive terminal (+) of the flat battery.
3. Connect the other clamp of the red cable to the positive terminal (+) of the battery in good condition
or to the positive terminal (+) of a recovery vehicle.
4. Connect the clamp of the black cable to the negative terminal (-) of the battery in good condition.
5. Finally, connect the other black clamp to any part of the engine block or chassis frame (metal part).
ATTENTION:
To avoid the risk of a spark and potential explosion due to hydrogen from the battery, never make
this final connection to the negative terminal (-) of the damaged battery.
6. Leave the flat battery to recharge for a few minutes, or even longer if possible, before attempting to
start.
7. Start the engine of the vehicle. Once started, leave the engine running for a few minutes.
8. Without turning off the engine you have helped to start, disconnect the jump start cables from the
battery or the booster in reverse order.
ATTENTION: At the end of the operation, make sure that the red and black cables do not touch each
other when they are still connected to a battery.
IMPORTANT: Corroded battery terminals may interfere with, or even prevent the tractor from
starting.
GUID-E2027280-7FFF-4D23-BC48-6F082B47738D [V1]
2. Safety instructions and safety points
T CVT 37
ACW2071910

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Valtra T195 CVT and is the answer not in the manual?

Valtra T195 CVT Specifications

General IconGeneral
BrandValtra
ModelT195 CVT
CategoryTractor
LanguageEnglish

Related product manuals