ValueHD VHD-V500N - Restore Factory Defaults

ValueHD Corporation
36
Language: menu language, Optional items: EN,
Chinese
Protocol: Control protocol type. Optional items:
AUTO, VISCA, PELCO-D, PELCO-P
V_Address: Protocol address, To be decided
according to the agreement, AUTO, VISCA protocol
Optional items: 1 ~ 7
P_D_Address: PELCO-D protocol Optional
items: 0 ~ 254
P_P_Address: PELCO-P protocol Optional
items: 0 ~ 31
V_AddrFix: If I can change through the serial
port of infrared switch, Optional items: On,
Off(When set to On, useless in 88 30 01 FF
Command)
Net Mode: Set the serial port control
networking, Optional items: Serial, Paral
Baudrate: Serial port baud rate. Optional items:
2400, 4800, 9600
8. RESTORE DEFAULT
Move the cursor to the Restore Default item in
the main menu and press [home] button, RESTORE
DEFAULT menu appears, as shown in the following
figure.
Restore: Confirm restore factory settings.
RESTORE DEFAULT
Restore? No
Change Value
[Home] OK
[Menu] Back
SETUP
Language EN
Protocol VISCA
V_Address 1
V_AddrFix Off
Net Mode Serial
Baudrate 9600
Select Item
Change Value
[Menu] Back