Adjustment of the bicycle
Before using the bicycle, adjust it to the measurements of the cyclist. This is of great
importance, especially the saddle and the handlebars.
If an optimal adjustment of the bicycle, as defined in the instructions, is not possible, you
can contact your dealer for a fitting solution.
The brakes are correctly adjusted and should only be adjusted by the dealer during periodic
maintenance.
Take care that fingers and limbs do not get trapped while adjusting the bicycle.
Saddle height
When the cyclist is sitting on the bicycle and can
put a foot on the pedal in the lowest position, the
saddle height is correct. Adjust the saddle height
in such a way that the leg is stretched but relaxed
in that position.
To adjust the saddle:
1. Loosen the screw [A].
2. Slide the saddle to the correct height.
3. Tighten the screw.
Do not pull out the saddle pin further than the mark. The tube will not
go into the shank deep enough and will risk breaking off, which can lead
to serious injuries.
To Next Page
Loading...
