Camera settings
Country
Enter a 2-letter combination code to indicate the country which the certificate will
be used in. For instance, type in “US” to indicate United States.
State or province
Enter the local administrative region.
Locality
Enter other geographical information.
Organization
Enter the name of the organization to which the entity identified in “Common Name”
belongs.
Organization Unit
Enter the name of the organizational unit to which the entity identified in “Common
Name” belongs.
Common Name
Indicate the name of the person or other entity that the certificate identifies (often
used to identify the website).
Valid days
Enter the period in days (1 to 9999) to indicate the valid period of certificate.
Click on <OK> to save the Certificate Information after complete.
IP Filter
The IP Filter setting can be found under this path: System> Security> IP Filter.
With IP Filter, users can allow or deny specific IP addresses from accessing the
camera.
Enable IP Filter
Check the box to enable the IP Filter function. Once enabled, the listed IP ad-
dresses (IPv4) in the <Filtered IP Addresses> list box will be allowed / denied to
access the camera.
Select
<Allo
w>
or
<Den
y> f
rom
the
drop-down
l
ist
and
click
on the
<Apply>
button
to determine the IP filter behavior.
Add IP Address
Input IP address at the blank space below the <Filtered IP Address> list and click
<Add>. The newly-added address will be shown in the list. Up to 256 IP address
entries can be specified.
In addition, to filter a group of IP addresses, enter an address at the blank space
followed with a slash and a number ranging from 1 to 31, ex. 192.168.2.81/30. The
number after the slash can define how many IP addresses will be filtered. For de-
tails, please refer to the following example.
Example: Filtering a group of consecutive IP addresses
The steps below show what will be filtered when 192.168.2.81/30 is entered.
To Next Page
Loading...
Need help?
General
