Why does my vanEE AI Industrial Equipment show error E26?
The vanEE Industrial Equipment might show error E26 if it is exposed to ambient temperatures outside of its operating limits. Check if the air exchanger is within the specified temperature range. If the problem persists, replace the electronic assembly.
Why does my vanEE AI show error E43?
The vanEE Industrial Equipment might show error E43 if it is exposed to ambient temperatures outside of its operating limits. Check if the air exchanger is within the specified temperature range. If the problem persists, replace the electronic assembly.
What to do if my vanEE AI Industrial Equipment displays error E42?
If your vanEE Industrial Equipment displays error E42, replace the electronic assembly.
What to do if my vanEE AI displays error E22?
If your vanEE Industrial Equipment displays error E22, follow these steps: First, unplug the unit and visually inspect the supply damper system. Clean the filters, distribution registers, and the outside supply hood. Also, inspect the ducting to make sure it's not squeezed or bent, then plug the unit back in. If the problem persists, remove the ducting from the supply path and select MAX on the LCD screen to see if the unit can reach the selected flow. If it can, review the ducting path. If the issue remains, select the MIN and MAX flow setting values on the LCD screen and reset the unit. The MAX flow value will then display on the screen. If the MAX flow is above the desired MAX flow, set the MAX and MIN flows. If the problem still isn't fixed, replace the supply blower and repeat setting...
What to do if my vanEE AI displays error E32?
If your vanEE Industrial Equipment displays error E32, follow these steps: First, unplug the unit and visually inspect the exhaust damper system. Clean the filters, distribution registers, and the outside exhaust hood. Ensure that no non-return damper is installed in the exhaust hood, as it can freeze in winter. Inspect the ducting to ensure it is not squeezed or bent, then plug the unit back in. If the problem persists, remove the ducting from the supply path and select MAX on the LCD screen to see if the unit can reach the selected flow. If it can, review the ducting path. If the issue remains, select the MIN and MAX flow setting values on the LCD screen and reset the unit. The MAX flow value will then display on the screen. If the MAX flow is above the desired MAX flow, set the MAX and ...
General| Brand | vanEE |
|---|---|
| Model | AI Series |
| Category | Industrial Equipment |
| Language | English |
To Next Page