EasyManuals Logo

Vanguard System VM-5500 User Manual

Vanguard System VM-5500
50 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #15 background imageLoading...
Page #15 background image
VM-5500 Operator’s Manual
2018
Rev 0418.1 | Quick Start
15
2.3.6 Product Sensor “Seeds”
If you had selected Seeds at the start of this Quick Start the following Screen will appear. The Product
Sensors Seed screen is where you can set your Desired target rate for your Seeds/Acre. After you enter
this rate the default Maximum and Minimum Limits will be calculated with +/- 20%. You may change
percentages or enter absolute numbers.
Press and hold Blue entry fields for a pop-up Numeric Keypad.
Figure 9 Product Sensor Setup for Seeds
Press the Desired Rate Button
After you enter the Desired Value you can likewise change the calculated Limits. Notice the Require List
for our example is now down to only one parameter.
At this point you may also adjust the Sensor Gain parameter. The Sensor Gain is a method to adjust the
actual number of seeds being planted to what is being detected by the seed sensor. You can move

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Vanguard System VM-5500 and is the answer not in the manual?

Vanguard System VM-5500 Specifications

General IconGeneral
BrandVanguard System
ModelVM-5500
CategoryMonitor
LanguageEnglish