Vantrue E2 User Manual

- 9 -
Installation of car charger: Connect one end of the car charger to the
car cigarette lighter and the other end to the Type C port on the front
camera GPS mount. When the green light of car charger is on, it
means it is powered on.
3.
Note: There are two protective films numbered 1 and 2. Please remove
the protective film from No. 1, paste the electrostatic sticker on the
windshield, and then remove the protective film from No.2. Remove
the 3M tape from the mount, then fix the mount and camera on the
electrostatics stickers.
Please peel off this mask
AFTER application completed
Please peel off this
mask BEFORE application
EN EN EN EN

Vantrue E2 Specifications

General

Front Lens Angle	160°
GPS	Yes
Wi-Fi	Yes
Parking Mode	Yes
G-Sensor	Yes
Loop Recording	Yes
Rear Camera Resolution	1920x1080 (1080P)
Storage	Up to 512GB microSD card
Operating Temperature	-20°C to 70°C (-4°F to 158°F)
Power Supply	12V car adapter