FCC Compliance Statement
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
Note: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to reasonably avoid harmful
interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy. If not installed and used in
accordance with the instructions, it may cause
harmful interference to radio communications.
However, there is no guarantee that such interference
will not occur under a particular installation.
If this equipment does cause harmful interference to
radio or television reception, which can be
determined by switching the device on, the user is
encouraged to try to correct the interference by one
or more of the following measures:
Adjust the direction or position of the receiving
antenna.
Increase the separation between the equipment
and receiver.
Connect the equipment into an outlet on a circuit
other than that to which the receiver is connected.
Consult the dealer or an experienced radio/TV
technician for help.
Caution: Any changes or modifications to this device not
explicitly approved by manufacturer could void your
authority to
operate this equipment.
This equipment complies with FCC radiation exposure
limits set
forth for an uncontrolled
environment. This equipment should be installed and
operated
with minimum distance 20cm
between the radiator and your body.
To Next Page
Loading...
