Step 4: Connect the rear camera's power cable to the
extension cable.
After snaking your rear camera's extension cable, connect
the power cable to your rear camera's extension cord.
Step 5: Connecting the red wire with the reverse light wires.
Reverse light wires are normally located on the rear side of
your car although their placement may vary so be sure to
refer to your car's manual. Once spotted, use a pair of
pliers or wire stripper to peel the rubber to expose the live
wire.
For safety, make sure you do this while the car is turned off.
Lastly, please poke the red positive bare wire through the
positive reverse light wire and then wrap with an electrical
tape.
- 28 -
To Next Page
Loading...
