After inserting a memory card, the camera
will (by default) immediately
start loop
recording video when connected to a
power source and powered ON. If the
device is not connected to a power
source, it will not immediately start on and
record.
While recording, the LED indicatorwill blink
and a red dot will flash on the top left of
the screen. You can stop/start the record-
ing at any time by pressing the UP button.
By default, the Loop Recording Time is 3
minutes. Please go to “Record
Setup”►“Loop Recording” to change it
to 1 minute or 5 minutes.
The loop recording video file name format
is “Year_Date Time_ SerialA.
MP4 ”. For example:“2019_0301_060101_001A.MP4”. the suffix A
indicates front cam recorded files, while the suffix B refers to rear
- 13 -
4.3
Set Date/Time
4.4
Loop Recording
2019 / 04 / 11
17 : 16 : 39
YY / MM / DD
Time&Date
Open the MENU interface, navigate to“System Setup”►“Time &
Date”, and press the OK button to set the date/time. Navigate UP
or DOWN to select date and time values. Press OK to confirm and
proceed. To finish setup, just press the MENU button to exit.
NOTE:
Date format is YY/MM/DD with the time in 24 hour format.
cam recorded files . Standard files are stored in the “Video/Nor-
mal” folder. When the Micro SD card is full, the camera will write
over older files.
When Loop Recording is turned off, the camera will record video
in 15
minute clips, but will not overwrite old videos when the
storage card is full.
00:00:16
000MPH
14:42:252019/04/10
EV
0.0
1920x1080P 30FPS
HDR
3
To Next Page
Loading...
Need help?
General
