17
The precautions to be taken in the case of blockage of the Venturi or Venturis.
1. Do not block Venturi or Venturis!
2. Check and make sure there is no insect net in the Venturi or Venturis before using the
BBQ, especially for long time no use.
Regulator and Hose Requirements:
The regulator used with your grill must be CE approved, and conform to local codes. Also the
hose connect to the tank must be CE approved and conform to local codes. The length of the
hose shall be no excess 1.5m.
Hose must be changed according to expiry date or when national conditions require it. Worn or damaged
hose must be replaced.
Note: Always checks for gas leakage before use. Change old/broken hose if necessary.
Tank Requirements:
The tank used with your grill must meet the following requirements:
1. Measurement: must conform to local codes.
2. Maximum Capacity: must conform to local codes.
3. Gas type:
a. I
3+
: Butane 28~30mbar
Propane 37mbar
b. I
3B/P(30)
: G30(Butane),G31(Propane) or their mixtures 28~30mbar
c. I
3B/P(50)
: G30(Butane),G31(Propane) or their mixtures 50mbar
d. I
3B/P(37)
: G30(Butane),G31(Propane) or their mixtures 37mbar
4. Constructed and marked in accordance with the specification for the limitative gas.
5. Be arranged for vapor withdrawal.
6. Has a collar to protect the tank valve.
7. No dent or rust. A dented or rusty gas tank may be hazardous.
For your safety:
Ensure that the black plastic grommets of the regulator provided are in place and that the
hose does not come into contact with the heat shield or the grill head.
Make sure hose is not subjected to twisting after installation.
The gas bottle have to be placed next to BBQ on a flat surface and away from ignition
source.
Make connection or change of the gas bottle in a ventilated area and away from flammable
source.
After each replacement of gas bottle make leakage test.
Connect the regulator to the gas tank:
VERY IMPORTANT:
a. THE REGULATOR SHALL INCORPORATE IN SUCH A LOCATION THAT IT WILL NOT
ATTAIN A TEMPERATURE ABOVE 140℉（60℃）.
b. THE REGULATOR SHALL INCORPORATE A PRESSURE RELIEF VALVE OR
OVERPRESSURE DEVICE.
To Next Page
Loading...