Need help?Do you have a question about the Vaporesso GTX GO 40 and is the answer not in the manual?
Connect the battery and pod magnetically for a stable assembly.
Remove old coil by pulling from drip tip, install new coil, and align base.
Unscrew top cap, fill through slot, replace cap, wait 5 mins for coil to soak.
Rotate pod to align air-inlet port with battery to adjust airflow volume.
Device detects ultra-low resistance when starting to vape.
Device detects a short circuit.
Device does not detect an atomizer when starting to vape.
Device detects an ultra-high resistance when starting to vape.
General| Battery Capacity | 1500mAh |
|---|---|
| Output Power | 5-40W |
| Charging Port | USB Type-C |
| Pod Capacity | 2ml |
| Coil Compatibility | GTX Coils |
| Dimensions | 110.3mm x 22mm |
To Next Page