14
·The device search lasts for 2 minutes, and the backlight mode is restored after the device
is connected.After the setting is successful, switching the Bluetooth channel will automatically
match the set device.
·Long press Fn+Q/W/E for 3 seconds to reset the corresponding Bluetooth channel
and enter the matching state again.
·Fn+X long press for 3 seconds and flash the backlight (white) 3 times to clear the pairing record
before Bluetooth(Can only be cleared in Bluetooth mode)
2.4G Pairing Operation
·In wireless mode(Bluetooth & 2.4G ), long press Fn+R for 3 seconds to pair 2.4G, then the green
light under R key flashes.
·Enter the pairing state, plug in the 2.4G receiver and use it.
·The code matching time is 20 seconds, and the backlight mode will be restored after the code
matching is successful.
(The factory has been paired with the user directly plug the receiver can be used)
To Next Page
Loading...