VARMILO Sword 68 - Lighting Effects Control; Tap Layer Function Introduction

15
Current light effect
·Light effect switching: Fn+Left Shift or Right Shift, switch the previous or next light effect
mode under the current light effect.
·Colour switching: Fn+ "{" or "}" to switch the previous or next color under the monochrome light effect.
·Lighting Speed: Fn+ "←" or "→" reduces or increases the dynamic speed of the current RGB light effect
·Lamp Brightness: Fn+ "↓" or "↑" to reduce or increase the light effect brightness of the
current RGB light effect.
·Light effect restore: Fn+ "D", long press for 3 seconds, the light effect restore factory Settings.
Tap Layer Function Introduction
·Tap layer function can be on or off in Driver-Global Settings.
·When the Tap function is turned on, a short press on the Tap key triggers the Tap layer function,
and a long press on the Tap key will be the original Tap key.
·The higher the sensitivity, the longer the key press time required to trigger the Tap function.
·Switch to the Tap layer in the key setting of the driver software to modify the Tap layer function.