Varytec Hero Scan 150 - Page 36

Use the ‘Calibration’ menu to adjust the start parameters of the device.
Press [Enter] to activate the main menu and use [Up] or [Down] until the display shows
‘Settings’ . Conrm the selection with [Enter] and use [Up] or [Down] to select the submenu
‘Calibration’ .
Conrm the selection with [Enter]. The device prompts you to enter a password. Successively
press [Up], [Down], [Up] and [Down] and conrm the selection with [Enter].
Use [Up] or [Down] to select the desired parameter you want to set.
Parameter Function
‘All To Origin’ Resets all parameters of the calibration to factory settings.
‘Pan’ Sets the home position of the rotation.
‘Tilt’ Sets the home position of the inclination movement.
‘ Color’ Sets the initial colour of the spot.
‘Gobo’ Sets the rst gobo.
Calibrating
Operating
36
Hero Scan 150
LED scanner