Vasco Digipass 270 - INIT PIN input and user PIN change

INIT PIN input and user PIN change (Initialization)
e Digipass can be used to sign documents only after the INIT PIN is changed to the user-defined PIN.
Before you start the procedure, please think of Your PIN (five digits).
To change INIT PIN you have to do the following:
CommentsDisplayAction№
1 PIN e device prompts You to input initial
PIN (INIT PIN).
Input Your INIT PIN2 XXXXX -
If INIT PIN is correct:3 NEW PIN e device prompts You for PIN, which is
going to available only to You.
Input Your PIN4 XXXXX -
Repeat the input of
Your PIN
5
PIN CONF e device prompts You to repeat the input.
If new PIN entered
correctly;
6 NEW PIN CONF e Digipass initial PIN change was
successful.
XXXXX e message FAIL appears, when repeated
PIN does not matches first entered PIN.
You will be offered to input a new PIN
again (p.4).
Press the button
and holding it press,
the button.
2
JSC “PNB Banka”
DP270 User’s Guide