20
2. Put the RF remote control in frost protection mode: press 3x
on the button then press for 5 sec.
OK
mode
4. When the RF remote control and the
blower are linked, the symbol
appears on the LCD screen.
5 sec.
3. To ensure correct operation of the radiator, the power of the
radiator must be adjusted via the RF remote control. This step is
(only) automatically addressed during the linking process, for
controls that deliberately could not be programmed during the
production process.
The power is set to 500W by default.
Use the and keys to set the
power (see rating plate radiator).
The RF remote control is in frost protection if this symbol is
visible on your screen:
Don´t know the output of your radiator?
Contact your installer.
To Next Page
Loading...
